ELECTRIC UNIVERSAL MOTOR JP-120 | JP-140

Electric universal motor JP-120 | 140

Electric universal motor JP-120 | 140

230 Volt, 50/60 Hz, 250 or 450 Watt, IP 24, double insulation protection class II, over load protection switch with integrated low voltage release. Thermal protection, 5 m cable with plug.
Also available in 115 volts, 60 Hz.
Electronic speed control JP-120 | 140

Electronic speed control JP-120 | 140

The speed of the drum pump motor JP-120 / JP-140 can be controlled via a knob on the side of the motor housing electronically. This enables an adjustment of the flow rate. The electronic speed control is available as an option.

230 Volt, 50/60 Hz, 250 Watt or 450 Watt, IP 24, alternatively 115 Volt, 60 Hz

The drive is a compactly built, not explosion-proof, internally ventilated universal motor.

The lightweight, handy and powerful device can be used as drive for the pump tubes of the laboratory and drum pumps and is useful in this combination for many thin fluid, neutral, aggressive and non-flammable media. Its sophisticated, technically clear structure ensures an efficient and safe use when transferring a variety of water-like liquids.

The drum pump motor is characterized not only by its light weight (2 and 2,3 kg) but also by its elegant design and ease of use. The non-stationary and stationary usable drive is particularly suitable for intermittent operation. As internally ventilated motor it has an optimal air cooling, low noise level and ensures high operational safety and long time life.

The motor housing made of polypropylene ensures high chemical resistance when aggressive vapours of acids and alkalies are present.

The standard in the on/off switch integrated low voltage release is intended to prevent an uncontrolled start of the drum pump motor after a power failure or voltage drop and thus guarantees maximum safety. By the presence of a thermal protection the life of the engine is significantly increased.

The flow rate of the media that will be pumped can be adjusted by the optionally available speed control that is mounted laterally in the motor housing and therefore adapted to the needs of the user.

The maximum density of the media is for the JP-120 universal motor 1.2, the maximum viscosity 200 mPas.

The maximum density of the media is for the JP-140 universal motor 1.4, the maximum viscosity 400 mPas.

Contact form

Use this form to send us your request.