Company | References | Product news        

Electric universal motor
JP-360

230 Volt, 50 Hz, 640 Watt, IP 55

The drive JP-360 is a compactly built, not explosion-proof, externally ventilated universal motor.

This handy, very robust and powerful motor can be used to drive the suction tubes of drum pumps. In this combination it is suitable for many thin liquid and slightly viscous, neutral, aggressive and non-flammable liquids (max. 600 mPas). Its sophisticated, technically clear structure ensures an efficient and safe use when transferring a wide range of media.

The drum pump motor is characterized not only by its light weight (5,5 kg) but also by its elegant design and ease of use. The non-stationary and stationary usable drive is particularly suitable for intermittent operation. As externally ventilated motor it has an optimal air cooling, low noise and ensures high operational safety and long lifetime.

By the built-in soft-start module, the motor runs slowly and allows a controlled medium transport.

The coated motor housing made of aluminium ensures a high chemical resistance when aggressive vapours of acids and alkalies are present.

The standard integrated low voltage release is intended to prevent an uncontrolled start of the drum pump motor after a power failure or voltage drop and thus guarantees maximum safety.

The flow rate of the media to be pumped can be regulated by a speed control that is integrated in a keyboard at the top of the motor handle. By means of four speed steps flow rates of 50, 60, 80 and 100 percent can be selected. Therefore the flow rate can be adjusted to the needs of the user.

The maximum density of the media is for the JP-360 universal motor 1.5, the maximum viscosity 600 mPas.

 

Integrated electronic speed control

 

The speed of the drum pump motor JP-360 can be controlled electronically via a integrated display on the handle. This enables an easy adjustment of the flow rate by the user.

Motor without pump tube
Version Voltage Order No.
without LVR, with SC 230 V 1~, 50 Hz, 640 W  1360 2302
with LVR + SC 230 V 1~, 50 Hz, 640 W  1360 2303
LVR: Low voltage release
SC: Speed control

Operating  data JP-360
Flow rate (with hose
and oval gear meter)
Ø 41 mm up to 93 l/min* (Rotor)
Ø 41 mm up to 74 l/min* (Impeller)
Head Ø 41 mm up to 11 m* (Rotor)
Ø 41 mm up to 26 m* (Impeller)
Viscosity up to 600 mPas*
Density up to 1,5*
* Test media water 20°C, pressure pipe 1″, oval gear meter, measured values: ± 5%

JP-360-380_ver_


Electric universal motor JP-360

230 Volt, 50/60 Hz, 640 Watt, IP 55, overload protection with integrated low voltage release and integrated speed control. 5 m cable with plug.

 

foerderkennlinie_fasspumpen_jp-360_en